Radiometric dating In , shortly after the discovery of radioactivity , the American chemist Bertram Boltwood suggested that lead is one of the disintegration products of uranium, in which case the older a uranium-bearing mineral the greater should be its proportional part of lead. Analyzing specimens whose relative geologic ages were known, Boltwood found that the ratio of lead to uranium did indeed increase with age.
After estimating the rate of this radioactive change, he calculated that the absolute ages of his specimens ranged from million to 2. Though his figures were too high by about 20 percent, their order of magnitude was enough to dispose of the short scale of geologic time proposed by Lord Kelvin. Versions of the modern mass spectrometer were invented in the early s and s, and during World War II the device was improved substantially to help in the development of the atomic bomb.
Soon after the war, Harold C. Wasserburg applied the mass spectrometer to the study of geochronology. This device separates the different isotopes of the same element and can measure the variations in these isotopic abundances to within one part in 10, By determining the amount of the parent and daughter isotopes present in a sample and by knowing their rate of radioactive decay each radioisotope has its own decay constant , the isotopic age of the sample can be calculated.
For dating minerals and rocks, investigators commonly use the following couplets of parent and daughter isotopes: The SHRIMP Sensitive High Resolution Ion Microprobe enables the accurate determination of the uranium-lead age of the mineral zircon, and this has revolutionized the understanding of the isotopic age of formation of zircon-bearing igneous granitic rocks.
Another technological development is the ICP-MS Inductively Coupled Plasma Mass Spectrometer , which is able to provide the isotopic age of the minerals zircon, titanite, rutile, and monazite. These minerals are common to many igneous and metamorphic rocks. Such techniques have had an enormous impact on scientific knowledge of Earth history because precise dates can now be obtained on rocks in all orogenic mountain belts ranging in age from the early Archean about 4 billion years old to the early Neogene roughly 20 million years old.
The oldest known rocks on Earth, estimated at 4. A radiometric dating technique that measures the ratio of the rare earth elements neodymium and samarium present in a rock sample was used to produce the estimate.
Also, by extrapolating backward in time to a situation when there was no lead that had been produced by radiogenic processes, a figure of about 4. This figure is of the same order as ages obtained for certain meteorites and lunar rocks. Between and he elucidated the complex sequence of chemical reactions attending the precipitation of salts evaporites from the evaporation of seawater.
His success at producing from aqueous solutions artificial minerals and rocks like those found in natural salt deposits stimulated studies of minerals crystallizing from silicate melts simulating the magmas from which igneous rocks have formed.
Bowen conducted extensive phase-equilibrium studies of silicate systems, brought together in his Evolution of the Igneous Rocks Experimental petrology also provides valuable data on the stability limits of individual metamorphic minerals and of the reactions between different minerals in a wide variety of chemical systems.
Thus the metamorphic petrologist today can compare the minerals and mineral assemblages found in natural rocks with comparable examples produced in the laboratory, the pressure—temperature limits of which have been well defined by experimental petrology. Another branch of experimental science relates to the deformation of rocks.
In the American physicist P. Bridgman developed a technique for subjecting rock samples to high pressures similar to those deep in the Earth. Studies of the behaviour of rocks in the laboratory have shown that their strength increases with confining pressure but decreases with rise in temperature.
Down to depths of a few kilometres the strength of rocks would be expected to increase. At greater depths the temperature effect should become dominant, and response to stress should result in flow rather than fracture of rocks. Rubey , demonstrated that fluids in the pores of rock may reduce internal friction and permit gliding over nearly horizontal planes of the large overthrust blocks associated with folded mountains.
More recently the Norwegian petrologist Hans Ramberg performed many experiments with a large centrifuge that produced a negative gravity effect and thus was able to create structures simulating salt domes, which rise because of the relatively low density of the salt in comparison with that of surrounding rocks. With all these deformation experiments, it is necessary to scale down as precisely as possible variables such as the time and velocity of the experiment and the viscosity and temperature of the material from the natural to the laboratory conditions.
In another German physicist, Max von Laue , realized that X-rays were scattered and deflected at regular angles when they passed through a copper sulfate crystal, and so he produced the first X-ray diffraction pattern on a photographic film. A year later William Bragg of Britain and his son Lawrence perceived that such a pattern reflects the layers of atoms in the crystal structure , and they succeeded in determining for the first time the atomic crystal structure of the mineral halite sodium chloride.
These discoveries had a long-lasting influence on crystallography because they led to the development of the X-ray powder diffractometer, which is now widely used to identify minerals and to ascertain their crystal structure. The chemical analysis of rocks and minerals Advanced analytic chemical equipment has revolutionized the understanding of the composition of rocks and minerals.
For example, the XRF X-Ray Fluorescence spectrometer can quantify the major and trace element abundances of many chemical elements in a rock sample down to parts-per-million concentrations. This geochemical method has been used to differentiate successive stages of igneous rocks in the plate-tectonic cycle.
The metamorphic petrologist can use the bulk composition of a recrystallized rock to define the structure of the original rock, assuming that no structural change has occurred during the metamorphic process. Next, the electron microprobe bombards a thin microscopic slice of a mineral in a sample with a beam of electrons, which can determine the chemical composition of the mineral almost instantly.
This method has wide applications in, for example, the fields of industrial mineralogy , materials science , igneous geochemistry , and metamorphic petrology. Micropaleontology Microscopic fossils, such as ostracods, foraminifera, and pollen grains, are common in sediments of the Mesozoic and Cenozoic eras from about million years ago to the present.
Because the rock chips brought up in oil wells are so small, a high-resolution instrument known as a scanning electron microscope had to be developed to study the microfossils.
The classification of microfossils of organisms that lived within relatively short time spans has enabled Mesozoic-Cenozoic sediments to be subdivided in remarkable detail.
This technique also has had a major impact on the study of Precambrian life i. Carbonaceous spheroids and filaments about 7—10 millimetres 0. Seismology and the structure of the Earth Earthquake study was institutionalized in with the formation of the Seismological Society of Japan under the leadership of the English geologist John Milne. Milne and his associates invented the first accurate seismographs, including the instrument later known as the Milne seismograph.
From studies of the Croatian quake of Oct. Today there are more than 1, seismograph stations around the world, and their data are used to compile seismicity maps.
These maps show that earthquake epicentres are aligned in narrow, continuous belts along the boundaries of lithospheric plates see below. The earthquake foci outline the mid-oceanic ridges in the Atlantic, Pacific, and Indian oceans where the plates separate, while around the margins of the Pacific where the plates converge, they lie in a dipping plane, or Benioff zone, that defines the position of the subducting plate boundary to depths of about kilometres. Since , additional information on the crust has been obtained from the analysis of artificial tremors produced by chemical explosions.
These studies have shown that the Moho is present under all continents at an average depth of 35 kilometres and that the crust above it thickens under young mountain ranges to depths of 70 kilometres in the Andes and the Himalayas. This is seismic reflection profiling, the main method of exploration used by the petroleum industry.
During the late s a new technique for generating seismic waves was invented: